What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 28.06.2025 12:16

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Barnstars:
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
How many women have accidentally pooped their pants and became turned on afterwards?
The bolt then partially travels down the line to your home.
eight
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Third case of bird flu detected at commercial farm in Maricopa County - ABC15 Arizona
nine
A fuse is a non-resetable over current circuit protector.
This one hit behind the barn.
When was you wife swapping fantasy started?
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
At least they know the answer if they wanted it.
What happened in a tent while you were camping that you will never forget?
It also is a device that limits the change in current flow.
Here is a simplified AC power diagram.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
Why is Donald Trump criticized by so many people?
Upvotes:
What is lightning?
He then describes Rainy Season and Lightning.
How likely do TWS earbuds explode these days? I'm still using wired earbud because I'm paranoid.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
so, what happens?
The MOV will conduct when the voltage exceeds 50% of line voltage.
These U.S. States Have the Highest Rates of Dementia - Gizmodo
This is where this question deviates from being a 'generic' question, and becomes more specific.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
‘Resident Evil Requiem’ Sets February 2026 Release From Capcom - Variety
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
In schematic diagrams this is the symbol for a fuse:
This is the picture of an electronic coil of wire wound around a core of magnetic material.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Edit 2024–10.
WWDC 2025: What to Expect From macOS 26 Tahoe - MacRumors
2024–10–14 [Omar Gharbi Omar Gharbi ]
but I think this circuit , shows a few more pieces.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
I post the exact comment here.
One is “what exactly is in a ‘surge protector’ ? ”
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
One
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
These are simplified answers to the original question, and does not change anything I wrote above.
But… the neutral is now “floating” because of the 1 ohm resistance.
The other is “what does a “fuse” do?”
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
what exactly is a ‘surge’ protector?
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
the problem then depends on "how fast does the fuse operate?".
Because the load is inductive, the current lags the voltage.(by a bit).
For this case there are devices called Metal oxide varistors (MOV).
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
So, the voltage could go up to 500 volts, and the fuse will not open up.
At one ohm, the resistor has a maximum of 1 watt power.
Now when you have a certain ac resistance, then a current flows in a loop.
This is 'the assistant's answer'
a photo is worth a thousand words.
But it can get overloaded, and no longer works.
These devices are installed between the “hot” and “neutral” and protective ground.
He then describes the function of a fuse.
A circuit breaker is similar, but is resettable.
What does a fuse do?
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
There are two important concepts here.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
There are three different concepts here that are getting confused.
This device then solves the entire problem.
but this device (an Inductor) … impedes the rapid changes in the current.
This is where the MOV conducts again, and dissipated the energy.
He then asserts :
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
An AC voltage/ current source, and an ac inductive load.
(Dc diagram shown, AC is similar).
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
[old diagram got deleted by accident]
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
The third is lightning and “how it gets conducted into a home.”
Can the fuse protect the electronic devices from lightning instead of a surge protector.
2024–10–16 [ OO OLAOYE OYEBODE ]
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
It seems Mohan does not understand the difference between a comment and an Answer.
First Sentence:
2024–10–10[John johnson John Johnson ]
[image of Common-mode choke]